civstraw005 1.194

What you can do with IC-705 control civstraw(civstraw005)
　*Requires pairing with ICOM IC-705 via Bluetooth
　　.
*When you are offline, you can change the CIV address by performing List read on P.3 and reading the CIV address. TXT.
*Turn on the transceiver of the device. MENU SET>External Terminal>CI-V CI-V Transceiver ON
1. Reading and writing frequency list Reading and writing frequency list
　1) Since pre-information is written in ROM_assets (read-only), read it
　2) Tap save to restore to a readable and writable file (RAM_writable)
　3 ) The list can be changed with (RAM_Writable)
　4) Tap the READ frequency book to read
2. Utilization of a list
　1) Frequency, mode (LSB.. etc.), filter (FIL1.. etc.) ) Tap to send information to the transceiver
　2) Scan button Tap (STOP→START) to scan the frequencies on the list, and open the squelch to stop for about 2 seconds.
　3) You can change the frequency information (list) by tapping the filter
　4) You can sort the frequencies and memos in ascending or descending order
　5) To delete, swipe the row to the left
　6) To sort one row, touch the row 7) Commands to move up and down
　are pre-registered for experiments Operate valid commands on P.2
3. Change frequency Frequency change
　1) Change by operating the slide bar or tapping the frequency display
4. Voice/squelch Level, variable notch, IF adjustment, Voice, squelch level, variable notch, IF adjustment, voice
　1) P.1 button tap or P3 right image tap
5. Finish The finish button is on p.3.
　1) There is a finish button on p.3 6. 　CIV
address and Bluetooth device name settings
Tap the model of
　　*Since we have not confirmed anything other than IC-705, please change it in the list *
　　Valid with CIV address .TXT under READ frequency book (Tap READ frequency book to return)
7. About frequency steps
　1) It is not a setting inside the device
　　* It can be changed step by step from 0.001 to 10000 KHz
　2) Transceiver TS setting is also implemented
8. Energy saving sw Energy saving sw
1)S To read the meter, frequency, etc., the command is turned by a timer, so if you are concerned about battery consumption, please turn it on.